US $25.35 - 43.90
US $32.50 - 56.28 -22%
n***n 01 Jul 2020
Everything came very quickly (10 days), perfectly packed. The board normally connected and got out of the box, on the connectors for drivers for some reason, I was confused by the jumper, I had to pick them up, but these are trivia. The drivers work very quietly, and in general the board is much better stock on Ander 3. I had to hang out a little with custom firmware, but in the end, everything seems to work well. In the kit there is a SD card for 128mb, it is enough for firmware and several print files. While testing work, if there are data-I'll complement the review.
T***n 04 Jul 2020
S***h 10 May 2020
The sky and the earth compared to the drain. It works quietly as in the morgue. Duck controlled delivery and installation. I recommend who hasn't changed these firewood on the stock Ender. Don't know your print!
Is this work also for Ender 3 pro version?
And more memory card with firmware on board (did not check)
Are you aware of software problems of skr mini e3 v1.2? When you release a stable version via github. the device has a freezing problem.
Worked straight out of the box
BIGTREETECH SKR mini E3 mounted эндер 3 require something? Or just took out the old (drain), and set a new just typing?
I threw the wires and in the way. Chic
Кто нибудь пробовал ставить на ANET A-8 ?
No but what is the problem it can work on almost any printer if it is right to do everything
Integrated into the board means soldered? Which one is better than 2209 or 2208?
Yes the integrated board has the drivers soldered. The 2209 are better. They run cooler and can support endstop detection.
For work Esra board, I must change the old and connect the cables and ready? Or need intalar some system on board?
It is plug in play. Just change the place, all connections has the same fittings ourselves places. Search YouTube channel called brmakers, he teaches as exchange.
Hi for creality cr10 s5
Very quiet you can only hear the fans
does the Skr mini E3 comes with eeprom?
it uses progmem to emulate eeprom. u can configure size an placement in firmware see youtubers
The dip version is already firmware downloadable?, and should the processor bask at idle?
Firmware Merlin 2,0 raw but fit. The processor is heated and at idle because it also works and consumes power
Comes roster to install and already? Or must put some software or set up something for the Ender 3 pro
comes pre installed with marlin 2.0.x, all setup for Ender 3/pro. prints as soon as u unplug the old board, an plug in the new one. I thought it wasn't working as it was so quiet.