US $1.09 -15%
A***h 23 Oct 2020
Arrived in the Shell פצפצים. Thin relative. I 'd favor layer protection extra. Look right בסהכ. More don't tried it. אכתוב again after assembly. It's relatively affordable.
G***e 25 Jun 2020
The device works, I wanted though check whether funzionasse also on anycubic predator. Unfortunately doesn't
M***a 20 Sep 2020
You have No installation and configuration instructions. It looks good. When I do the test, I'll tell you.
what is the switch inside?
A micro-switch from the typical end of the race.
Works for the ENDER 3 pro and where it should be connected to the plug in the printer?
yes work, u need to breakout pin 27, either use adapter or snip some them wires
will this work on Duet 2 wifi
Sensor for 3D printer stops the supply of plastic when it breaks
Does it work with Ender 5?
So I have Trinxy X5SA printer.This item work good. I have BTT skr 1.4 turbo motherboard with Marlin 2.0 open source firmware this item work good. This item is simple swich .
1-where do you connect it to on motherboard? 2- does it need software upgrade?
You need to look at the instructions to your board.
How do you install on the ender3?
Plug in the end port and redirect it to the Philomena sensor. Or plug into the display port. For breakage sensor.
Please more information for pin out confirmation for Ender 3 pro?
It's ok, but my original CR-10S5 it shorts when filaments inserted. Not going to update or rewire. Check your motherboard. Seller is great to deal witt.
does this work with ender 3 pro?
It must see the card, and do the parameterization firmware
A question for a printer rush i3b would be possible to put it and if you know how Thanks
No answers yet.