US $15.99 - 32.77
US $19.99 - 40.96 -20%
D***o 22 Dec 2020
Yak description. Without opening. Packing приклеїлася to the table, but 10 hvilin and all kind). I'll pass and finish the reviews. As a description. Without holes. The package is glued to the table, but 10 minutes and all is well). I will check and supplement the review.
C***i 08 Sep 2020
conforme o anúncio. aparentemente muito bem construído.
B***g 23 Dec 2020
could be put a bit more effort to package.. eg. cardboard support on both sides..
Guys Tell, the photo can see that there is no hole of the table! To the silicone heater is озможность make in corners of the screw holes?
It Is the adhesive backing. Polished The alcohol and stuck. Do not fall off
Can be directly on the glass!
Only if the glass breaks off problematic, and so of course you can :)
witch is the plus and the minus of the power cables?
you can connect any way, it is not imprtat which cable is +, or - .
Can it be cut to size?
can you add holes for printer carriage?
No the plate must be stuck under a Aluminum plate
What is the maximum temperature it holds
I can only say for sure.
Heating pad is AC 220 or DC 220
There are two models. THE material is bought DC.
Suitable for heated table 3D printer for 220 V?
It is and designed for heating from 220 V
planning to buy 24v 800w 400*400 heater pad..but my board requires 12v to operate it's printerboard.
It doesn’t matter, you must connect the heated bed to a board through external mosfet. Otherwise it overheat mosfet on your’s board if it not supports current over 40A.
Can the corners or any regions be trimmed or drilled for mounting holes?
Think not worth