US $19.80 -34%
S***v 26 Oct 2020
Total time to Moscow 15 days I haven't installed it yet. Took for ender-3 All is well but the wires had to be lengthened by about 20 cm. I just passed the wires through the corrugated because I think it's right. Otherwise, everything is fine. There will be time, I will finish and unsubscribe. But I'm afraid it won't be soon.
AliExpress Shopper 12 Jul 2020
From order to получения-21 day. Packing is postal bag with bubble film and pencil case. Description corresponds. Track tracked.
D***n 23 May 2020
It works well, I almost forgot about the table alignment. Once there was some glitch: I come, and the carriage rose up to 10 centimeters from the table, and 3dtouch constantly flashed. I don't know what it was, I haven't seen it happen, it hasn't been repeated yet. Not sure that the problem was exactly in 3dtouch.
Contact the owners Ender3-still missing wires attached to connect? Some people write, that yes, others are also increasing 10-15 cm.
The wires will come up
is this v3?
5v 2+ amps
Is that version have aluminum pin or plastic pin?
Who is connected to lerdge-X?
There is no need to try to set the sensor point to the level with the nozzle. I got above the nozzle by 1.45mm, this value is entered in the settings, to be selected in an experienced way.
AND if my printer from infintary, not the most popular so let's say company, whether it is suitable for and how to set it up?
With Clipper norms works
Ok do sensor works with such results of tests on м48? Range: 0.019 Standart deviation: 0.005726 Range: 0.015 Standart deviation: 0.004844 Range: 0.015 Standart deviation: 0.004600 Range: 0.011 Standart deviation: 0.003654 Range: 0.015 Standart deviation: 0.004900
You have a great accuracy for the price of the sensor. My kinematics printer a lame, precision below, but enough for good sticking to the table. Hands so when did not align.
Did someone get to work normally with SKR mini E3 v1.2? Can you share the configuration? Thank you.
I also looked, I will do it. The configuration is in his description under the video.
Suitable ANET A6?
But do not forget, you need to change the firmware and be prepared for that will fly loader
Why doesn't it work as well as the original?
For Marlin fit put on tarantula, forgot about the calibration, the first layer is ideal.