US $1.51 - 2.96
US $1.86 - 3.65 -19%
A***v 17 Oct 2020
Delivery in 18 days from the time of order. The programmer on the chip KS, works normally firmware updated.
V***h 22 Sep 2020
Good board, connected everything works. The neighbor mehatronic doubts the quartz resonator that he runs faster than necessary-I'll check in. I plan to collect a weather station with a CO2 sensor. Let's see what happens.
k***v 02 Aug 2020
Shipping fast. I haven't checked yet. As I will check the feedback. On the chip sterto name. The Tsuki are encrypted. On the patch board STM32F.
Гироскутер under the throttle flash can?
You can, there is a free firmware on the Internet. Already made electric scooter
Tell me who works with him through STM32 ST-Link Utility me when you connect the settings is seen, but when нажитии OK writes that mistake when connected to программатору, type use mode with Reset. on different computers, the same problem
Not to программатору, and to the board. If you have STM32F103C8T6, the case in position jumpers. Before connecting of utilities necessary switch jumper BOOT0 and BOOT1 out 0 to 1.
702533120039209 the order has not arrived, he was closed. What to do?
I have once. Can sell for $. Still not needed
Добрый день! Сколько банок эта BMS балансирует?
How many order
it can прошить stm32f407?
not understand one, хуя on! excellent leave the feedback and write “operation more not tested"...
Pierced two kinds of прогр. Which sends the seller. Both work. Debugging of qtcreator set up. One in the past month 4. Second the substitution.
30eur shipping to Slovakia. Please add different option for shipping!
Nrf52832 stitches normally?
NRF51 is stitched normally, nRF52 is out of stock for checking.
hi, direct order two why? so that they are fast?
For different projects, so as not to unravel the layouts, one for nRF51, the other for STM32, also this programmer can be modernized by donating swim port, which will not allow use with stm8.
Who can tell where exactly it connectors TX and RX or TXD and RXD
There are no such connectors. This is the STM microcontroller programmer, not the UART-USB adapter